Propeller placement article (external link)

There are many considerations where to put a propellers in a small aircraft or RPV. The common place to put them is at the nose. The biggest reason and driver for this placement is that it is advantageous for CG location. However, from aerodynamic standpoint that is not very optimal. There was discussion at HBA Forums about propeller placement and this document was linked (it studies difference of prop placed in pusher and tractor configuration):

http://www.icas.org/ICAS_ARCHIVE_CD1998-2019/ICAS2000/PAPERS/ICA0344.PDF

Optimal place is behind the wing, a bit above the wing centerline (only small part of the prop circle goes below the wing). This placement has the typical CG challenges with it. And it will require either pylon on the wing, or a pylon on the fuselage (assuming a single fuselage). There is then the question about the effect of the body to the prop located near the fuselage behind the trailing edge of the wing. There might be unfavorable flow due to the effects of the wing-fuselage joint that this study did not take in account.

According to the article, it was possible to increase quite significantly the Clmax of the wing with the rear placement of the propeller due to the suction effect to the wing. This leads to interesting thought about a line-thruster - multiple small electric motors turning multiple relatively small props behind the trailing edge of the wing, providing suction to the whole wing surface, or at least large part of it. Interesting question then would be that would a varying thrust angle be beneficial, should the pylons be actually mounted on the flaps? Downside of this is that this may lead to flap mechanism that is not very lightweight as the flaps have to take all the torque and push from the motors. Normal flap mechanisms would not like that.

Any comments on this?